Categories: AudioLinear Amplifier

1W Stereo Audio Amplifier using LM386N

This is 1W stereo audio amplifier with LM386N. The output power is 1 watt for each channel, so it should be use two ICs of LM386N National Semiconductor for stereo channel. This circuit belongs to kitsrus.com and the kit is available there or at electronickits.com. This circuit only need 10mA current with best voltage supply is 6-12VDC. No heatsink required for normal usage.

There are only a few external components, the IC  contains most of the necessary circuitry. C1, C5 are  the input coupling capacitors, which block any DC  that might be present on the inputs. C2, C9 maintain  DC bias levels in the gain adjustment (feed back)  circuit. C4 provides power supply decoupling, and  C6, C8 are the output coupling capacitors. C10, R1  and C11, R2 act as zobel networks providing a high  frequency load to maintain stability where loud speaker inductive reactance may become excessive.  The pot provides adjustable input level attenuation.

Components List:

Capacitors:
C1, C5 2.2 uF / 50Vecap _________ 2
C2, C9 10 uF / 25V ecap _________ 2
C3, C7 100 nF mono (104) ________ 2
C4 100 uF / 16V ecap ____________ 1
C6, C8 470 uF / 16V ecap ________ 2
C10, C11 47 nF mylar (473) ______ 2

Resistors :
R1, R2 10 ohm ___________________ 2
Pot 1 10k ohm stereo pot ________ 1

Misc. :
IC 1, 2 LM386N __________________ 2
8 pin IC socket _________________ 2

Download the complete explanation of 1W Stereo Audio Amplifier using LM386N:

Download the LM386N Datasheet:

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago