This is a 220V LED flasher circuit which is intended as a reliable replacement to thermally-activated switches used for Christmas tree lamp-flashing. This a low cost circuit and easy to built since it only use little amount of electronic components..
Schematic diagram:
Component Parts:
R1_________ 100K R2,R5______ 1K R3,R6______ 470R R4_________ 12K C1_________ 1000uF 25V D1-D4______ 1N4007 D5_________ SCR P0102D Q1_________ BC327 Q2_________ BC337 SK1________ Female Mains socket
How the circuit works:
The device formed by Q1, Q2 and related resistors triggers the SCR. The flashing frequency is provided by R1, R2 and C1. To change flashing frequency value, just set C1 value from 100 to 2200uF, don’t modify R1 and R2.
Best performances are obtained with C1=470 or 1000uF and R4=12K or 10K. Due to low consumption of normal 10 or 20 lamp series-loops, very small and cheap SCR devices can be used, e.g. C106D1 or TICP106D.
Warning! : The circuit is directly connected to the 220V mains, please be careful when try and use this circuit
Source: redcircuits.com
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…