This is a circuit of a touch switch used to turn on and turn off the electronic device that is connected to the 220V home electrical installations. This is a very simple circuit which use SCR T103 as the switching part.
Components List:
R1 : 2M2
R2 : 10K
R3 : 1K
R4 : 2K2
R5 : 100K
R6 : 47K
C1 : 1NF
C2 : 47uF/25V
D : 1N 4002
SCR : T 103
TR1,2 : FCS 9014
This circuit is connected directly to a 220V home electrical installations. “LOAD” on the schematic diagram above, is an electronic device with 220V AC current consumption.
Note: This circuit is a circuit with high voltage and current, you should use adequate safety devices before perform the experiment.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
