Categories: AudioLinear Amplifier

50 Watt Power Audio Amplifier

Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo).

Schematic diagram:

50 Watt Power Amplifier circuit diagram


PCB layout:

Power Supply Circuit:

This amplifier require dual polarity output power supply (+, ground and -). Use this power supply circuit:

Transformer: 3-5 Ampere, 24V secondary output
Diode: Diode bridge 5A or 4 piece of single diode 5A

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago