Emergency Light + Alarm

This is the circuit diagram of emergency light included the alarm circuit to show you that there is no power source in your building due to shutted down or short circuit. When the electric in your home/company has been shutted down for maintenance and or shutted down due to short circuit, you may need this circuit for backing up your electric power for temporary usage.

When power supply is restored, the lamp or the alarm is switched-off. A switch provides a “latch-up” function, in order to extend lamp or alarm operation even when power is restored.

Emergency Light and Alarm Circuit

This circuit is permanently plugged into a mains socket and NI-CD batteries are trickle-charged. When a power outage occurs, the lamp automatically illuminates. Instead of illuminating a lamp, an alarm sounder can be chosen.

Components List:

R1____________220K   1/4W Resistor
R2____________470R   1/2W Resistor
R3____________390R   1/4W Resistor
R4______________1K5  1/4W Resistor
R5______________1R   1/4W Resistor
R6_____________10K   1/4W Resistor
R7____________330K   1/4W Resistor
R8____________470R   1/4W Resistor
R9____________100R   1/4W Resistor

C1____________330nF  400V Polyester Capacitor
C2_____________10uF   63V Electrolytic Capacitor
C3____________100nF   63V Polyester Capacitor
C4_____________10nF   63V Polyester Capacitor

D1-D5________1N4007 1000V 1A Diodes
D6______________LED  Green (any shape)
D7___________1N4148   75V 150mA Diode

Q1,Q3,Q4______BC547   45V 100mA NPN Transistors
Q2,Q5_________BC327   45V 800mA PNP Transistors

SW1,SW2________SPST Switches
SW3____________SPDT Switch

LP1____________2.2V or 2.5V 250-300mA Torch Lamp Bulb
SPKR___________8 Ohm Loudspeaker
B1_____________2.5V Battery (two AA NI-CD rechargeable cells wired in series)
PL1____________Male Mains plug

Circuits Works:
Mains voltage is reduced to about 12V DC at C2’s terminals, by means of the reactance of C1 and the diode bridge (D1-D4). This avoids the use of a mains transformer.

Trickle-charging current for the battery B1 is provided by the series resistor R3, D5 and the green LED D6 that also monitors the presence of mains supply and correct battery charging.

Q2 & Q3 form a self-latching pair that start operating when a power outage occurs. In this case, Q1 biasing becomes positive, so this transistor turns on the self latching pair.

If SW3 is set as shown in the circuit diagram, the lamp illuminates via SW2, which is normally closed; if set the other way, a square wave audio frequency generator formed by Q4, Q5 and related components is activated, driving the loudspeaker.

If SW1 is left open, when mains supply is restored the lamp or the alarm continue to operate. They can be disabled by opening the main on-off switch SW2.

If SW1 is closed, restoration of the mains supply terminates lamp or alarm operation, by applying a positive bias to the Base of Q2.

Notes: Close SW2 after the circuit is plugged.

source: redcircuits.com


Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.