Harmonic Sweetener Circuit Electronic

Harmonic Sweetener Circuit Electronic

Harmonic Sweetener Circuit Electronic

The input of this circuit is amplified by the first op amp, in which the output goes to two different elements in this circuit. The bottom half of the circuit is the clipper segment. The amplified signal goes through four other op amps, in which the wet signal that comes out of the 4th op amp in the clipper segment is clipped. This clipped signal is then outputted to a 10k trim potentiometer which controls the amount of clipped signal is added to the original amplified signal. The last op amp is an adder in which the original amplified signal and the wet clipped signal is added up and sent to the output.

This schematic diagram come from circuit: Harmonic Sweetener Guitar Effect.
Go to that page to read the explanation about above circuit design.

In the electrical sector, a schematic diagram is usually used to describe the design or model of equipment. Schematic diagrams are usually utilized for the maintenance and repair of electronic and electromechanical devices / units. Original schematics were made by hand, using standardized templates or pre-printed adhesive symbols, but nowadays Electrical CAD computer software is often used.

In electronic design automation, until the 1980s schematics were virtually the only formal representation for circuits. More lately, using the progress of computer system technology, other representations were introduced and specialized computer languages were developed, because with the explosive development of the complexity of electronic circuits, classic schematics are getting less practical. As an example, hardware description languages are indispensable for contemporary digital circuit design.

Leave a Reply

Your email address will not be published. Required fields are marked *