Mini FM Transmitter with 2 Transistors

Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »

Stereo Electret Mic Preamplifier

This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp.  For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:

5W Tube Amplifier with EL84

Here is the circuit diagram of the classic 5W Tube Amplifier with EL84 as the final amplification component. This is a single channel amplifier (mono) of course with single input and single output. You should build the two similar circuit to make it stereo.

35W Tube Power Amplifier with EL34

This is the circuit diagram of 35W Tube Power Amplifier with EL34. This tube amplifier designed in 1953 and worked from 1954 until 1989. If you’re interested with classic circuit and classic components, then you should try this circuit. The circuit is interesting but i think it is hard to find the tubes. Schematic Diagram:

50W Inverter 12VDC to 220VAC

This is the inverter circuit which capable to convert 12V DC to 220V AC dan handle about 50 Watts small electronic appliances. With this circuit, you can use a 12V accumulator / lead acid battery to operate some of your electronic appliances which not exceed 50W of total power consumption. Components List: R1=10Mohms R2=100ohms R3=1.2Kohms… Read More »

1.5 Watt FM Transmitter

This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to  use other input sources) and signal… Read More »

Sound Effects Generator (8 different sound) based IC HT2884

This is the circuit diagram of sound effects generator. All sounds in this circuit are generated by HT2884. The HT2884 is a CMOS LSI chip equipped with tone circuit, noise circuit, and other control logic to generate various sounds to be used in sound effects production. This IC features: single power supply (2.4V – 3.3V),… Read More »

Electronic Bird Chirp Sound Generator

This is electronic bird chirp sound generator circuit which used to produce a sound like bird’s chirp. The transformer is a small audio transformer, type LT700. The primary is center tapped with an impedance of 1Kohms at 1KHz . The secondary has an impedance of 8 ohms. The circuit works with 9V power supply.


Page 55 of 58« First...102030...5354555657...Last »