The following diagram is the schematic diagram of 4 transistors FM transmitter circuit designed by Paul K. Sherby. Components List: R1,R2,R8 = 1K R3 = 100K R4 = 150K R5,R7 = 10K R6 = 220 ohm R9 = 10 ohm P1 = 5K trimpot D1 = 1N4002 Q1,Q2 = 2N3904 Q3,Q4 = 7001, NTE123AP C1… Read More »
This circuit is a powerful three stage, 9V FM transmitter (Tx) with a range of up to 1 kilometer in the open. It uses an RF transistor in its output stage and two BC547″s for the first two stages. Distance of trans-mission is critically dependent on the operating Conditions (in a building or out on… Read More »
Here the simple and low cost FM transmitter circuit. The frequency range of this FM transmitter should be about 89MHz – 109MHz. Output power is about 9mW at 9V. Components List: Resistors: R1, R6 : 12K R2, R4 : 100K R3 : 22K R5 : 1K R7 : 100R Capacitors: C1 : 10uF/25V C2 :… Read More »
Below is the circuit diagram and PCB layout of FM wireless microphone: The range of frequencies for the FM broadcast band is 90MHz (MHz = Megahertz or 90 million cycles per second). Because the FM microphone has a variable tuned circuit, it can be tuned to a quiet spot on your local FM broadcast band… Read More »
This is long range FM transmitter with transmision power output is up to 15W. This 15W FM transmitter use power transistor BLY88C as the main transmitter amplifier. Building a good FM transmitter(88-110Mhz) begins with getting a good schematic. You don’t have to understand the precise working of the transmitter to build it. But some basic… Read More »
This is a mini fm transmitter circuit. I think this is the simplest one. Simple, easy and of course… inexpensive… The supply voltage is between 1.1 – 3 Volts with power consumption is 1.8 mA at 1.5 Volts. This circuit should be able to cover 30 – 50 meters of range max. at 1.5 Volts.… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »
This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to use other input sources) and signal… Read More »
This circuit is a wireless car alarm system that is built using two circuit modules, namely modules of transmitter and receiver modules. This circuit works on FM radio waves. Car alarms can be used on vehicles that have a 6-12VDC power supply. You can use the voltage stabilizer if your car power supply is too… Read More »