Categories: AudioLinear Amplifier

100W Audio Amplifier with Transistor BDW83D/BDW84D

Here is the circuit diagram of 100W audio amplifier which using power transistor BDW83D and BDW84D for the final amplification. It uses dual polarity power supply to work. Copyright belong to Smart Kit.

The circuit should be seen like this:

This is an exceptionally well designed amplifier, with a lot of power reserve, high fidelity, low distortion, good S/N ratio, high sensitivity, low consumption and full protection. Having all these almost ideal characteristics this amplifier is likely to become the basic building block of your future high fidelity system, or it can also become the element that will upgrade your existing system.

Schematic diagram:

Component part list:

PCB Layout:

Component placement:

Technical Specifications:

Output power (f=1 KHz, d=0.5 %): 100 W in 8 ohm
Supply voltage: ……………. СЃ 40 V
Quiescent current: …………. 50 mA
Maximum current: …………… 2.6 A
Sensitivity: . 600 mV
Frequency response: ………… 10-35000 Hz (-1 dB)
Distortion HD: …………….. 0.01 %
Intermodulation dist.: ……… 0.02 %
Signal/noise: 83 dBConstruction

Go to this page for detailed explanation.

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago