| R1-2-4-5=270Ω R3 = 2.7Ω VR1 = 10KΩ Log. Pot. TR1 = 470KΩ Trimmer IC1-2 = LM388 | C1 = 100uF/25V C2 = 100nF C3 = 10uF/25V C4-5 = 22uF/25V C6 = 47nF |
This is the 4W bridge amplifier circuit design based on power IC LM388 as the main component. Currently there are 2 chips of LM388 used since a LM388 only have one channel amplification. A single LM388 will deliver about 1.5W power audio output, while 2 pieces of it used with bridge connection, ten it will deliver up to 4W power audio output.
Notes:
For 6V supply and 4Ω loudspeaker, the circuit will deliver 1W audio output.
For 12V supply and 8Ω loudspeaker, the circuit will deliver 4W audio output.
Download LM388 datasheet for your 4W bridge amplifier reference:
» Download link
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…