This is the circuit diagram of 2000W class AB power amplifier uses 7 pairs MJ15003 and MJ15004 transistors for the final amplification block. The circuit operated with 90V DC symmetrical (dual polarity) power supply circuit. The transistors must be mounted on heatsink to prevent the overheating, maintain the transistors work in maximum performance.
This is linear power amplifier 2000 Watt which need advance knowledge in electronics since the schematic diagram is very complex for hand made circuit. I think you have to re-design the schematic diagram using circuit diagram software designer such as diptrace, eagle, expresspcb ect. Or just order the PCB online, they will be glad to… Read More »
Here the low resistance connection tester which can be used as cable or wire tester, soldered joints and other types of connection with resistance value between 0.25 and 4 ohm. Circuit Notes: This simple circuit uses a 741 op-amp in differential mode as a continuity tester.
This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »
This battery charger circuit is regulated and adjustable to make this circuit able to charge the mosto NiCAD battery. This adjustable regulated battery charger circuit will work for single cell or multi battery cell which connected with series/parallel connection. The maximum voltage of the batteries should be 18V maximum. Power transistors Q1 and Q2 are… Read More »
This is the CD Drives troubleshooting and repair tutorial for your electronic service reference. It should be work and also largely relevant for DVD/HD DVD/Blu-ray equipment. This document was developed specifically for the troubleshooting and repair of the CD players in component stereo systems, compact stereos, boomboxes, car units and portables, as well as CDROM… Read More »
This is the circuit diagram of 24 Watt class A linear audio amplifier, built and tested by Marc Klynhans from South Africa. The supply voltage can be between 34V and 46V and the quiescent current should be set to 1.7A measured through R25 (a voltage of 0.75V must be measured over R25 for a quiescent… Read More »
This is the simple and low cost 3 channels mini audio mixer circuit diagram. This circuit supplied using 9V power supply. There are high/low-sensitivity switchable inputs for each input channel and each channel used low noise and high gain transistor of BC550C.
Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »