Tone Control

Stereo Tone Control with Line In + Microphone Mixer


This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control between right and left channel, microphone volume control, line in volume control and master volume for both line in and mic control. The circuit is powered by a regulated symmetrical power supply. The PCB layout design for both tone control and power supply is provided here, complete with component placement. Good luck.

Stereo Tone Control Component List

INTEGRATED CIRCUIT

  • TL072 : 2
  • TL071 : 1

RESISTORS All 1/4W

  • 22K ohm (red, red, orange) : 10
  • 10K ohm (Brown, Black, Orange) : 10
  • 1K ohm (brown, black, red) : 3
  • 100K ohm (brown, black, orange) : 3
  • 100 ohm (Coffee, Black, Coffee) : 4
  • stereo/dual potentiometers 100K ohm : 3
  • stereo/dual potentiometers 10K ohm : 2
  • mono/single potentiometers 10K ohm : 2

CAPACITORS

  • 1uF/25V electrolytic capacitor : 4
  • 10uF/25V electrolytic capacitor : 1
  • 4.7uF/25V electrolytic capacitor : 2
  • 6.8nF (682) polyester capacitor : 2
  • 1.5nF (152) polyester capacitor : 2
  • 47nF (473) polyester capacitor : 2
  • 1nF (102) polyester capacitor : 2
  • 100nF (104) polyester capacitor : 4
  • 2200uF x 25 V electrolytic capacitor : 2
  • 1uF nonpolar capacitor (105) : 5

Stereo Tone Control PCB Layout and Component Placement

Power Supply Circuit

The power supply type for the stereo tone control is symmetrical and regulated and on its output we use +15 and -15 VDC. The LM7815 will deliver stabilized +15VDC and the LM7915 will deliver stabilized -15 VDC. For symmetrical source, the TL072 VCC range will be 7V up to 36V, so you may use a pair of regulator IC LM7805/LM7905 up to LM7815/7915.
Below is the schematic diagram, pcb design and component layout:

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

100W Power Amplifier Based IC TDA7294

This is a very interesting circuit design to assemble. There are 4in1 amplifier module in…

55 years ago