Categories: AudioLinear Amplifier

2 x 12W Stereo Amplifier with TDA1521/TDA1521Q

This is a stereo audio amplifier circuit which will deliver 12W audio power output on each channel. This circuit built based on single IC TDA1521 or TDA1521Q, supported with a few external components. General purpose power supply can be used to operate this amplifier circuit, recommended voltage: 24VDC (asymmetrical).

The TDA1521/TDA1521Q is a dual hi-fi audio power amplifier encapsulated in a 9-lead plastic power package.
The device is especially designed for mains fed applications (e.g. stereo tv sound and stereo radio). A heatsink is required to prevent IC overheating.

TDA1521 Features

  • Requires very few external components
  • Input muted during power-on and off
  • (no switch-on or switch-off clicks)
  • Low offset voltage between output and ground
  • Excellent gain balance between channels
  • Hi-fi according to IEC 268 and DIN 45500
  • Short-circuit-proof
  • Thermally protected

This hi-fi stereo power amplifier is designed for mains fed applications. The circuit is designed for both symmetrical and asymmetrical power supply systems. An output power of 2 x 12 watts (THD = 0,5%) can be delivered into an 8 W load with a symmetrical power supply of ± 16 V.

The gain is fixed internally at 30 dB. Internal gain fixing gives low gain spread and very good balance between the amplifiers (0,2 dB). A special feature of this device is a mute circuit which suppresses unwanted input signals during switching on and off.

Download the TDA1521/TDA1521Q Datasheet:
[wpdm_file id=54]

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago