Categories: AudioLinear Amplifier

35W Power Amplifier with STK-082

Here the great 35W power amplifier with single IC STK-082 from Sanyo Semiconductor. Simple circuit with high power output.. 🙂

This circuit uses symmetrical (dual polarity) power supply with maximum power voltage is 43V based on the datasheet document. The recommended voltage operation is +/- 30V. For stereo application, you just need to build two similar circuit. Use minimum 2A center tap transformer for stereo channel amplifier.

Use this kind of dual polarity power supply circuit:

STK082 Features:

  • @lMST, l Channel  by 2 Power Supplies
  • Differential amp. constantc current driving.
  • Capable of tone controlling.

Download the STK-082 datasheet from the following link:
[wpdm_file id=62]

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago