Dual Output Stabilized Power Supply

This is a dual regulated and stabilized power supply, usually used to supply amplifier circuit, it also known as split powersupply. There are 3 output that are (+) voltage, (0) Ground (normal), and (-) voltage. The current output max about 0.3-0.5 A. For higher current output, power transistor is needed.

Please take a note that this circuit require center tap transformer. for example, if you need 12v output, you should connect J1 to 15v transformer output, J2 connected to 0v and J3 connected to another 15V.

The IC works ac stabilizer and regulator. There are 2 types of IC that are:

  • 78xx > for positive voltage
  • 79xx > for negative voltage

“xx” is the voltage output from IC. example, use 7809 if you need +9VDC output and 7909 for -9VDC output. For 9V output, the IC  input voltage should be at least 12V. For 12V output, the input voltage at regulator IC should be at least 15V.

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago