Categories: Radio

FETs based Micro-Spy

This is Micro-Spy circuit which designed using FET components..

Circuit Notes:

  • The FETs, T1 and T2, are BF245 N-channel FET’s model. It can be replaced with a NTE133 or ECG312. The BA121 varactor diode can be replaced with a ECG/NTE611. USW stands for ‘Ultra-Short-Wave’.
  • The oscillator has a frequency of approximately 100MHz.
  • L1 = 7 turns of 0.8mm Silverwire on a 5mm round Ferrit-core (adjustable).
  • Feedback via 16pF capacitor. No interference from antenna on resonance-loop.
  • Distance is at *least* 300 meters!

Micro-Spy circuit diagram by Tony Van Roon

circuit diagram

Leave a Comment
Share
Published by
circuit diagram
Tags: Micro-Spy circuitMicro-Spy diagramMicro-Spy schematicMicro-Spy with fetssimple Micro-Spy
54 years ago

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

54 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

54 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago