This is the circuit diagram of power amplifier 45W using power uPC 1230 as the main component. The pre amp head has been added in the circuit using uPC 1032. This is an popular old circuit for hobbysts and the 45 Watt amplifier circuit should be working fine since the PCB already on the market… Read More »
This is the simple project of small sound amplifier for ears or often called hearing aid device or hearing loss amplifier. This circuit was already tested on some patients and give significant improvement in the hearing ability to the patients. It consumes a very small amount of power within the range of 10 milliwatts. Furthermore,… Read More »
This is the circuit diagram of 70W OCL power amplifier with output power of 70 watts single channel. It uses power transistor TIP2955 and TIP3055 as main component. The power supply used for this amplifier is a symmetrical / dual polarity power supply with output voltage 25V – 32V. This amplifier dan be used to… Read More »
This is the circuit diagram of 24 Watt class A linear audio amplifier, built and tested by Marc Klynhans from South Africa. The supply voltage can be between 34V and 46V and the quiescent current should be set to 1.7A measured through R25 (a voltage of 0.75V must be measured over R25 for a quiescent… Read More »
This long-range FM radio transmitter has an additional RF power amplifier stage, after the oscillator stage. The extra RF power amplifier used to strenght up the power output to become 200-250 milliwatts. With a great matching multi-element Yagi antenna or 50-ohm ground—plane antenna, this transmitter can give great good signal strength up to a distance… Read More »
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
This is the circuit diagram of stereo tube amplifier using 6SQ7-GT and 6V6-GT. The tube amplifier circuit is uses the total of 5 power vacuum tube. The diagram is based on the output section design of typical late 1940’s old AM Trutone radio with 6 tubes. The output will be 4 Watts per channel (2x4W… Read More »
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »