This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
This is the circuit diagram of 70W OCL power amplifier with output power of 70 watts single channel. It uses power transistor TIP2955 and TIP3055 as main component. The power supply used for this amplifier is a symmetrical / dual polarity power supply with output voltage 25V – 32V. This amplifier dan be used to… Read More »
Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »
This 400W power amplifier circuit often called as “safari” amplifier. The below circuit design is for single channel only, build two identical circuit for dual/stereo channels. The 400W power amplifier designed using two couples of power transistors that are TIP31 with TIP32 and 2N3055 with MJ2955. These types transistor are well known and widely used… Read More »
This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home… Read More »
Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
This 6V and 12V car battery charger circuit can be automatically charged, quickly and correctly, 6V and 12V batteries. Circuit design is divided into two series of modules that are: power supply module and the main charger module containing the regulator modules and direct current amplifier module.
This is high quality 0-30v stabilized variable power supply circuit diagram. You will able to adjust the output voltage from 0 volt up to 30 volt DC. You also able to adjust the current output value from 0.002 A to 3 A. This variable power supply incorporates an electronic output current limiter that effectively controls… Read More »