This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
The following is an electronic circuit called galaxy audio booster which serves to improve the performance of your audio system. This circuit uses an IC RC4558 in which there are two op-amp modules that can be used for stereo audio applications. The circuit is similar to stereo tone booster that uses the principle of High… Read More »
This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »
This is the circuit diagram of 24 Watt class A linear audio amplifier, built and tested by Marc Klynhans from South Africa. The supply voltage can be between 34V and 46V and the quiescent current should be set to 1.7A measured through R25 (a voltage of 0.75V must be measured over R25 for a quiescent… Read More »
Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »
This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
Above circuit diagram is the schematic of 1W stereo headphone amplifier. The circuit is built based TDA2822, designed for use in portable players, radios and other common electronic devices which can use headphone for the audio output.
The following diagram is the circuit diagram of Class-D audio power amplifier which built based on power chip TDA8929T. About TDA8929T: The power IC TDA8929T is the controller of a two-chip set for a high efficiency class-D audio power amplifier system. The system is divided into two chips: TDA8929T; the analog controller chip inside a… Read More »