This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »
This is the circuit diagram of 24 Watt class A linear audio amplifier, built and tested by Marc Klynhans from South Africa. The supply voltage can be between 34V and 46V and the quiescent current should be set to 1.7A measured through R25 (a voltage of 0.75V must be measured over R25 for a quiescent… Read More »
Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »
This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors. Power supply used is the type of dual polarity power supply… Read More »
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »
The following diagram is the circuit diagram of simple 4W audio amplifier based TDA1013B. The amplifier is based on integrated audio amplifier chip, TDA1013B which is able to gained the audio power output up to 4W at 8 ohm loads. Wide supply voltage range can be used for this circuit from 10VDC to 40VDC. Recommended… Read More »