This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control… Read More »
This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is an easy, low cost and easy built circuit of an electronic horn which is designed close to quadruple op-amp IC LM3900 (IC1). IC LM3900 has four independent operational-amplifiers (A1 through A4) having a large output voltage swing. It is able to operate at up to 32V DC. The 1st op-amp (A1) is designed… Read More »
Below circuit is the tone booster circuit. According to the name of circuit, the purpose is to amplify the sound signal to become more powerful in both low and high frequencies. There is no potensiometer used for bass/treble adjustment. Transistor type: Q1 – ztx384 ; Q2 – BC415p The circuit’s peaks frequencies is at 5000… Read More »
The following diagram is the schematic diagram of Active Tone Control circuit, or we often call this circuit as “ACTOR”. The circuit is quite simple, easy build and inexpensive, you can build this circuit with minimum / low cost. Active Tone Control or ACTOR is an active electronic audio circuit that serves to increase the… Read More »
This is a very basic circuit diagram of 3 band tone control. This basic tone control circuit was originally intended for home audio use, but should be able to be hacked into an effect circuit with very minor modification. Resistance value of resistor R1 is left up to the user depending on gain needs, R2… Read More »
Below is a mic compressor circuit that uses transistors as active components. VR1 and VR 2 is used to control the tone from the microphone, while VR3 and VR4 strengthening works to control the audio signal in the compressor mic. C10 must be used in this circuit. The circuit I got from my local computer… Read More »
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
This is a stereo audio tone control circuit which build based on IC LM1036. This circuit will controll bass/treble level tone, volume and balance between right channel and left channel (input 1 and 2 ). You may use this circuit for stereo applications such as car radio, TV and audio systems, mp3 player, dvd player,… Read More »