Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
Equaliser circuits typically divide the audio spectrum into separate frequency bands and have independent gain control for each band. The output of each band is mixed at IC4(A) and then fed to an audio power amplifier. Proper quality factor (Q) needs to be selected to avoid overlap in adjacent bands as this introduce colouration into… Read More »
This is the circuit diagram of electronic hearing aid featured with sensitive sound detection and energy saving, so this hearing aid will work in the long term with a 9V batery battery cycle. The common hearing aid circuits consume the battery energy continuously once they are turned on. This smart electronic hearing aid saves battery… Read More »
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
The following diagram is the circuit diagram of Class-D audio power amplifier which built based on power chip TDA8929T. About TDA8929T: The power IC TDA8929T is the controller of a two-chip set for a high efficiency class-D audio power amplifier system. The system is divided into two chips: TDA8929T; the analog controller chip inside a… Read More »
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
This is the design diagram of 5 band graphic equaliser circuit build using operational amplifier chips, the NE5532 or LM833. The op-amp ICs is a good choice because of inexpensive and comes with fairly good quality output. Each IC contains dual op-amps circuit, so you will need 4 ICs of NE5532 or LM833 to build… Read More »
The following diagram is the circuit diagram of 20W power amplifier which build based tube component EL34. EL34 is very famous tube and great for power tube amplifier. The circuit above is complete circuit contains tube amplifier circuit diagram and power supply circuit diagram. To make the stereo channel amplifier, build the similar amplifier circuit… Read More »
Here the schematic diagram of Fender Bassman 5F6-A tube amplifier. This circuit is a tube powered amplifier which is used as a bass guitar amplifier. Fender Bassman was a bass amplifier introduced by Fender in 1952. Although it was originally designed for bass guitars, it is often used for normal electric guitar in rock and… Read More »