Here is the dynamic microphone amplifier circuit diagram. This circuit should be perfect for dynamic microphone… Dynamic microphones are versatile and ideal for general-purpose use. They use a simple design with few moving parts. They are relatively sturdy and resilient to rough handling. They are also better suited to handling high volume levels, such as… Read More »
The circuit below is a Dynamic Mic Compressor circuit which is simple, easy to built, inexpensive but the results are quite satisfactory. Audio output sounded outstanding. The principle of this circuit is very simple, the first transistor is used as microphone pre-amplifier. Then a second transistor used as a buffer. And the third transistor is… Read More »
Here’s the circuit diagram of a 70W stereo power amplifier which built using single power IC STA550. The circuit is simple and require little additional electronic components to support the work of IC STA550. This power stereo amplifier works with dual polarity / symmetrical power supply. Since based to the datasheet, the negative supply range… Read More »
This is the circuit diagram of 80W power audio amplifier based on power IC LM12. The circuit kit is sold at electronic part/component store, the design is proven to be valid and work. This amplifier use dual polarity power supply to operate. Here the Amplifier Circuit Diagram: Here the PCB layout:
This is 68W power audio amplifier circuit which built based on single IC LM3886 from National Semiconductor. A LM3886 used for single channel operation. Dual polarity / split / symmetrical power supply used to operate this amplifier circuit. The LM3886 is a high-performance audio power amplifier capable of delivering 68W of continuous average power to… Read More »
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
Here is the Hi-Fi compressor circuit with pre-emphasis. The above diagram is a circuit for a high fidelity compressor which uses an external op-amp and has a high gain and wide bandwidth. An input compensation network is required for stability.
The following diagram is the FM transmitter circuit with FM transmision up to 4W. Voltage supply for this circuit is 12-16V with current consumption of 100-400mA. This circuit works with frequency of emission range of 88-108MHz. Transistor 2N2219 used as the main signal amplifier. 4 Watts FM Transmitter circuit design: Components List: R1, R2 =… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »