This the Good Quality FM transmitter for your stereo or any other amplifier gives you a pretty good signal strength up to a range of 500 metres having a power output of about 200 mW. This circuit can be operated with a 9V battery. The audio-frequency modulation stage is constructed close to transistor BF494 (T1),… Read More »
This is a mini FM transmitter built and powered using 2 transistors, designed by Tony van Roon. This small transmitter is simple to build and its transmissions could be picked up on any common FM radio. It possesses a range of approximately 1/4-mile (400 meters) or even more, depending on the line-of-sight, obstructions by big… Read More »
The following diagram is the circuit diagram of voice transmitter which use FM signal carrier to transmit the vioce signal to the FM receiver device. Components List: R1 = 4.7K R2 = 330 ohm C1 = 0.001uF (1nF) C2 = 10-40pF C3 = 4.7pF Q1 = 2N3904 L1 = see text Misc = Electret mike,… Read More »
Simple and easy build of sensitive FM transmitter circuit. The circuit only requires 2 transistors to work. *L1 = 0.1 Uh, 6 to 8 turns of 22 ga. hookup wire close wound around a 1/4 inch diameter non-conductive core such as a pencil Circuit Notes: Typically the default for the capacitors model is ceramic, preferably… Read More »
This is the active FM receiver antenna amplifier, used to boost the FM signal catch by the antenna, you may call circuit “FM antenna booster”. By working with only a small handfull of parts you can assembled this kind of reliable FM amplifier circuit. It runs with only 1 UHF/VHF type transistor, MFE201. This amplifier… Read More »
This is a very simple FM receiver which build based on one transistor only. No chip or another active component. The output is connected to earphones, you need an amplifier circuit if you want to listen the radio with a loudspeaker.
This is the circuit diagram of mini FM receiver that build based on single FM IC TDA7012T. Components List: R1 = 8kΩ2 R2 = 10kΩ R3 = 390Ω C1,C3 = 10nF C2,C6,C9,C16 = 100nF C4 = 33pF C5 = 25pF trimmer (Murata type TZB4Z250AB10R00) C7,C10 = 1nF5 C8 = 820pF C11 = 1nF C12 =… Read More »
Below is the circuit diagram and PCB layout of FM wireless microphone: The range of frequencies for the FM broadcast band is 90MHz (MHz = Megahertz or 90 million cycles per second). Because the FM microphone has a variable tuned circuit, it can be tuned to a quiet spot on your local FM broadcast band… Read More »
This is an active FM/AM/SW radio receiver antenna, can be used for FM radio receiver, AM radio receiver and SW (shortwave) radio receiver. This circuit use active component JFET VHF Amplifier MPF102 to boost the radio signal. It use 9VDC supply to work. On the shortwave band this active antenna is comparable to a 20… Read More »