This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four pieces of power IC TDA7294. It’s mean that every single channel of the circuit uses two ICs in bridge mode. In this application, the load value must not be less than 8 Ohms.
This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is a 200W power amplifier circuit project. The circuit features high power, good definition and very low noise. It delivers about 200 watts in 4 ohms loudspeaker: a 4 ohm speaker or two pieces of 8 ohm speakers in parallel. This 200W power amplifier using the complementary transistors of 2SC5200 and 2SA1943 as the… Read More »
This is the schematic diagram of 400W RMS stereo power amplifier which use power transistor to work. This amplifier in addition to providing good sound power, also with excellent quality and a high fidelity with low noise, to obtain the 400 watts we can put 2 speakers of 4 Ohms or 4 of 8 Ohms.… Read More »
This is the circuit diagram of 2000W class AB power amplifier uses 7 pairs MJ15003 and MJ15004 transistors for the final amplification block. The circuit operated with 90V DC symmetrical (dual polarity) power supply circuit. The transistors must be mounted on heatsink to prevent the overheating, maintain the transistors work in maximum performance.
This is linear power amplifier 2000 Watt which need advance knowledge in electronics since the schematic diagram is very complex for hand made circuit. I think you have to re-design the schematic diagram using circuit diagram software designer such as diptrace, eagle, expresspcb ect. Or just order the PCB online, they will be glad to… Read More »
This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »
This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
This diagram is a schematic diagram of RF amplifier circuit. The circuit will amplify the RF signal about 10 times, 100mW input power to 1.3W output power. It use a general NPN RF transistor 2SC1970. You may apply other transistors, for example 2N442. Circuit Diagram: Circuit Works: RF system and specially in RF amplifiers, this… Read More »