Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »
This is the 100 Watt power amplifier circuit based power amp chip LM3886. Single chip of LM3886 is able to generate power output up to 68W. In this 100W power amplifier circuit, the two of LM3886 are paralled to gain more powerful amplifier output. This amplifier can deliver about 50W into a 8-ohm speaker and… Read More »
This is the circuit diagram of 80W power audio amplifier based on power IC LM12. The circuit kit is sold at electronic part/component store, the design is proven to be valid and work. This amplifier use dual polarity power supply to operate. Here the Amplifier Circuit Diagram: Here the PCB layout:
This is 68W power audio amplifier circuit which built based on single IC LM3886 from National Semiconductor. A LM3886 used for single channel operation. Dual polarity / split / symmetrical power supply used to operate this amplifier circuit. The LM3886 is a high-performance audio power amplifier capable of delivering 68W of continuous average power to… Read More »
This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is a low cost, simple, yet a surprisingly powerful electronic siren powered by just a 9V battery. The circuit may provide the final circuit block module in an alarm circuit using a relay to activate it.
LM4809 Datasheet Document. Boomer audio power amplifiers were designed specifically to into 32 0.1% (typ) provide high quality output power with a minimal amount of external components. Since the LM4809 does not require bootstrap capacitors or snubber networks, it is optimally suited for low-power portable systems.
This is the circuit diagram of 230V automatic night lamp based photo resistor to sensing the light environment. When the condition is dark enough, the one or more lamps will be turned on and when the condition is bright enough, then the lamps will be turned off.
This is variable DC power supply circuit, or we can call it adjustable DC power supply which give us a 1.2V-25V output voltage. The power supply schematic above is taken from the datasheet of regulator LM338K manufactured National Semiconductor. The circuit uses IC LM338K as the voltage regulator, so we will get the stable and… Read More »