This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
This is a simple 20W bridge amplifier based on TDA7240A. This circuit is designed for car audio system, but you may use this circuit for your small home audio application… 🙂 . Schematic Diagram: This circuit operated with 18VDC asymmetrical power supply (positive (+) and ground only). Mount the power IC on a heatsink to… Read More »
This is a mono power amplifier circuit powered with single Amplifier chip STA5100. The chip will deliver single power output at 140 watt. For stereo application, just build two identical circuit and then doubled the power supply current output by increase the current value of the transformer. This amplifier powered using dual polarity (symmetrical) power… Read More »
This is a 20W Hi-Fi power amplifier circuit build based on single power amplifier IC TDA2040. The single TDA2040 has able to deliver 20W power output. The bridge amplifier which consist of double TDA2040 can deliver 30W power output (8 ohm loudspeaker). About power amplifier IC TDA2040: The TDA2040 is a monolithic integrated circuit in… Read More »
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
The following diagram is the schematic diagram fo Car Horn, you may try this circuit for your car modification… 🙂 Components List: R1 = 68K R2 = 2K2 R3 = 56K R4 = 3K3 R5,R6 = 4K7 R7 = 10K Pot/trimpot C1,C2 = 22nF C3,C5 = 100nF C4 = 1nF C6 = 220uF/25V IC1,IC2 =… Read More »