This is a logarithmic amplifier circuit based on National operational amplifier LM11C. Unusual frequency compensation provides this logarithmic converter a 100 us time continual from 1 mA down to 100 uA, escalating from 200 us to 200 ms from 10 nA to 10 pA. Optional bias electric current compensation can give 10 pA resolution from… Read More »
Tube Microphone Pre Amplifier Circuit Manual
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
Here is the dynamic microphone amplifier circuit diagram. This circuit should be perfect for dynamic microphone… Dynamic microphones are versatile and ideal for general-purpose use. They use a simple design with few moving parts. They are relatively sturdy and resilient to rough handling. They are also better suited to handling high volume levels, such as… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
This is the circuit diagram of low impedance microphone amplifier. The circuit designed for use with low impedance (~200 ohm) microphones. It will work with regulated voltages between 6-30VDC. If you don’t build the impedance adapter part with T1, you get a microphone amplifier circuit for higher impedance microphones. In this case, you should directly… Read More »
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four pieces of power IC TDA7294. It’s mean that every single channel of the circuit uses two ICs in bridge mode. In this application, the load value must not be less than 8 Ohms.
This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control… Read More »