This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »
This is schematic diagram of a video amplifier circuit, built based very high speed operational amplifier IC LH0032.
The following diagram is the circuit diagram of Class-D audio power amplifier which built based on power chip TDA8929T. About TDA8929T: The power IC TDA8929T is the controller of a two-chip set for a high efficiency class-D audio power amplifier system. The system is divided into two chips: TDA8929T; the analog controller chip inside a… Read More »
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
The following is a circuit of a simple AM transmitter. This circuit is available in kit form and can work well since the kit available on market. This circuit uses a combination of transistors SA101 and SA103, as the modulation signal amplifier.
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »