This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four pieces of power IC TDA7294. It’s mean that every single channel of the circuit uses two ICs in bridge mode. In this application, the load value must not be less than 8 Ohms.
This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
This is the circuit diagram of 2000W class AB power amplifier uses 7 pairs MJ15003 and MJ15004 transistors for the final amplification block. The circuit operated with 90V DC symmetrical (dual polarity) power supply circuit. The transistors must be mounted on heatsink to prevent the overheating, maintain the transistors work in maximum performance.
This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »
This is a 2W RF amplifier circuit build with single power MOSFET LF2810A. Figure A Figure A is the schematic of the microstrip single stage RF amplifier. The amplifier is based on the M/A-Com LF2810A MOSFET. The transistor is actually a 10 watt, 28 volt part, but provides adequate gain for this application at 12… Read More »
This diagram is a schematic diagram of RF amplifier circuit. The circuit will amplify the RF signal about 10 times, 100mW input power to 1.3W output power. It use a general NPN RF transistor 2SC1970. You may apply other transistors, for example 2N442. Circuit Diagram: Circuit Works: RF system and specially in RF amplifiers, this… Read More »
The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors. Power supply used is the type of dual polarity power supply… Read More »
This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home… Read More »
The following diagram is the circuit diagram of simple 4W audio amplifier based TDA1013B. The amplifier is based on integrated audio amplifier chip, TDA1013B which is able to gained the audio power output up to 4W at 8 ohm loads. Wide supply voltage range can be used for this circuit from 10VDC to 40VDC. Recommended… Read More »