This is a dual regulated and stabilized power supply, usually used to supply amplifier circuit, it also known as split powersupply. There are 3 output that are (+) voltage, (0) Ground (normal), and (-) voltage. The current output max about 0.3-0.5 A. For higher current output, power transistor is needed. Please take a note that… Read More »
This is definitely an effective 4-output stage stabilized DC power supply unit for testing electronic circuits. It delivers very well regulated and stabilised output, that is important for most electronic circuits to provide good results. The circuit gives you an audio-visual indication if there is a short circuit in the PCB under test, so the… Read More »
This is high quality 0-30v stabilized variable power supply circuit diagram. You will able to adjust the output voltage from 0 volt up to 30 volt DC. You also able to adjust the current output value from 0.002 A to 3 A. This variable power supply incorporates an electronic output current limiter that effectively controls… Read More »
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the main component. The pre amp head has been added in the circuit using uPC 1032. This is an popular old circuit for hobbysts and the 45 Watt amplifier circuit should be working fine since the PCB already on the market… Read More »
The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors. Power supply used is the type of dual polarity power supply… Read More »
The circuit diagram of 3V-30V/3A adjustable regulated power supply. This is an adjustable and regulated power supply with stabilized DC voltage between 3V and 30V provided that the consumption does not exceed 3A direct current. This circuit featured with short circuit protection and overload protection. This power supply unit can be used for general purposes,… Read More »
The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range. The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.
This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control… Read More »
Here is the schematic diagram of digital DC voltmeter built based IC ICL7107. The power supply for this circuit is +5V. You may use 9V battery and then use regulator IC LM7805 to achieve 5V stabilized voltage. This circuit will be good to display your power supply output.