This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
This is the 100 Watt power amplifier circuit based power amp chip LM3886. Single chip of LM3886 is able to generate power output up to 68W. In this 100W power amplifier circuit, the two of LM3886 are paralled to gain more powerful amplifier output. This amplifier can deliver about 50W into a 8-ohm speaker and… Read More »
The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range. The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.
This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image: This circuit should be connected to audio channel before amplifier… Read More »
Here’s the circuit diagram of a 70W stereo power amplifier which built using single power IC STA550. The circuit is simple and require little additional electronic components to support the work of IC STA550. This power stereo amplifier works with dual polarity / symmetrical power supply. Since based to the datasheet, the negative supply range… Read More »
This is the 60W power audio amplifier circuit based on IC TDA2052. If you want to create an amplifier that is able to produce a good sound output with low distortion audio, then this amplifier could be the right option for you. This circuit using power supply split type with a maximum input voltage of… Read More »