Here is the circuit diagram of battery tester designed by Matthew B.. This circuit can be used to measure the 1.5V and 9V battery. The circuit is very-very simple and very easy to built since it uses five resistors and a panel meter only, and of course it is inexpensive too.
Components List:
R1 = 18K Ohm
R2 = 240 Ohm
R3 = 8.2K Ohm
R4 = 3K Ohm
R5 = 10 Ohm
M1 = Panel Meter (Anyone will work)
Design Issues to consider:
It’s possible you have test with the values of R3 and R4 to have a precise reading from the meter. Every meter is different, so a little bit of experiencing using the resistor values is needed. Experiment by using a variable resistor instead of R3 & R4 to get a value of resistance that works.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Good stuff. I will build a couple of these circuits. Thanks.