This is a 100W RF amplifier built based on RF power transistor BLY94.
Active components: BLY94
Coaxial cable length : K x Lambda / 4, where K = 0.66 for 50 ohm cable and K = 0.8 for 75 ohm cable.
L1 = L6 = 2 turns / 1.5mm / 14mm
L2 = L7 = 8turns/0.8mm/4mm/ferite or HF
L3 = L8 = 4 turns / 2mm / 14mm / gap 1mm
L4 = L9 = 20turns/0.3mm / 3mm / ferite
L5 = L10 = 1 turn / 2mm / 15mm
BLY94 is a RF Power transistor in a SOT-55 case which operate in class-B with a Vce of 28V and a frequency transition of 175MHz. BLY 94 output power is 50W with a 7dB ( 6x ) power gain at 175MHz.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
nada nesecito el costo de este transistor urgente. gracias
hi dis is a good circuit