This is the circuit diagram of low impedance microphone amplifier. The circuit designed for use with low impedance (~200 ohm) microphones. It will work with regulated voltages between 6-30VDC. If you don’t build the impedance adapter part with T1, you get a microphone amplifier circuit for higher impedance microphones. In this case, you should directly… Read More »
This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This is low cost fully transistorised power inverter 60W circuit capable of driving medium loads of the order of 40 to 60 watts using battery of 12V, 15 Ah or higher capacity. Transistors T1 and T2 (BC548) form a 50Hz multivibrator. For obtaining correct frequency, the values of resistors R3 and R4 may have to… Read More »
This is a basic and very simple low power inverter to convert 12V DC to 120V AC. How much power this simple inverter can handle the load depends the transformer current value and transistors you use for Q1 and Q2.
Here is 100 Watt Inverter 12V DC to 220V AC schematic diagram. This circuit designed using the combination of main components IC CD4047, Transistor TIP122 and 2N3055.
This is the scheme diagram of 20 Watt stereo audio amplifier which use dual IC TDA2005, one IC for left channel and the another one for right channel. Each IC will give you 20 watt output, so the output will be 2×20 Watt. The supply voltage for this circuit is 8VDC to 18VDC, use regulated… Read More »
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
This inverter 12V DC to 240V DC can be used to power electric razors, stroboscopes and flash tubes, and small fluorescent lamps from a 12 volt car battery. In contrast to the usual feedback oscillator type of inverter, the oscillator of this inverter is separate from the output stage, which allows easy adjustment of the… Read More »