This is a simple 20W bridge amplifier based on TDA7240A. This circuit is designed for car audio system, but you may use this circuit for your small home audio application… 🙂 .
Schematic Diagram:
This circuit operated with 18VDC asymmetrical power supply (positive (+) and ground only). Mount the power IC on a heatsink to prevent over heating.
PCB Layout:
About TDA7240A:
The TDA7240A is a 20W bridge audio amplifier IC designed specially for car radio applications. The low external component count and compact Heptawatt 7-pin power package the TDA7240A occupies little space on the printed circuit board.
Reliable operation is guaranteed by a comprehensive array of on-chip protection features. These include protection against AC and DC output short circuits (to ground and across the load), load dump transients, and junction over temperature. Additionally, the TDA7240A protects the loudspeaker when one output is short-circuited to ground.
Download TDA7240A datasheet for circuit reference.
[wpdm_file id=77]
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
maY i suPPLy 12 volts ?
this 20W Bridge Amplifier using TDA7240A circuit diagram is nice!!
but where is the component list?
there is no component part list because the components value already descripted on the schematic diagram image.