This is the 220V / 200W lamp flasher circuit diagram. The frequency/speed of the lamp flashing can be adjust with the range of 1Hz to 5Hz. You can use the PR1 variable resistor (trimpot) to adjust the flashing speed. The duty cycle of lamp flashing can be adjusted using PR2 variable resistor.
The DC input power supply range is 6V to 12VDC. The main AC supply is about 230V. The output lamp to use is upto 200W lamp / bulb load. The recommended load is about 100W, but it said can be used for up to 200W. Don’t use the load higher than 200W lamp.
The following image is the part list for 220v 200W lamp flasher.
The PCB dimensions is 36 mm x 68 mm. If you want to mount the circuit on a case or fixed plate, then the four mounting holes of 3.2 mm each is required.
The power battery terminal and DC supply port is used for easy connecting the circuit to its supply and input/output.
The following is the looks of the kits. If you need the kit, try to find on online marketplace. 🙂
circuit source: iq-technologies.net
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…