This is 25W low power inverter which contain of only 9 parts and turn 10VDC – 16VDC into 115V / 60Hz square wave power. This circuit has capability to operate AC equipment up to 25W.
The first section of the 555 timer is wires as an astable oscillator with R2 and C1 setting the frequency. The output is available at pin 5. The second section is wired as a phase inverter. That output is available at pin 9. Resistor R3 and R4 keep output transistor Q1 and Q2 from loading down the oscillator.
The two transistors drive the transformer push-pull fashion. When one transistor is biased-on, the other is cut-off. The transformer is a 120V/18V center tapped that is connected backwards, so that is steps the voltage up rather than down. Oscillator circuit U1, R1, R2 and C1 operates from about 4 to 6V with very stable output.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
hi guyz!
i want to request from you if you could publish or share to me a circuit diagram
for 18vdc to 110vac 50w inverter. I really need this for my project. plz can u paste this before 12h-00 tomorrow 08/06/2011 and data manual
thanks
regard tjabadi m
hi there!
this power supply is very simple yet superb. thanks for this.
i want to request from you if you could publish or share to me a circuit diagram
for 12vdc to 24vdc. I really need this for my project. i have here a car battery and a solar charger, and my project is 24vdc.
thanks
ronell
This circuit is very easy and yet very useful. Thanks for providing such significant information.