Here the stereo power amplifier based on single IC STK4141II. This stereo amplifier circuit will deliver 25W audio power on each output channel.
Recommended voltage is 27.5V for 8 ohms speaker and 24.5V for 4 ohms speaker while the maximum voltage to supply this circuit should be about 41 VDC. This circuit operated with dual polarity (symmectrical) power supply, so center tap type of transformer should be used. Use minimum 2A transformer for better result.
Heatsink usage on the power IC is a must to prevent overheating and keep the good performance of STK4141II.
Use this STK4141II Datasheet for the circuit reference:
[wpdm_file id=74]
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Trancistor ànd ic integraed details
Ic data detail and ic integreed circuits