This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home audio system.
There are will be 8 pieces of them which should be attached together on aluminium heatsink. It’s will be better if you add small fan to blow the heatsink and transistors (just like fan and heatsink for computer processor).
This amplifier requires 42V dual polarity or symmetrical power supply with minimum transformer current output at 5A. And of course, with high power output, you also need good loudspeakers to make great audio output performance.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
hi..can u upload this picture again of this 300W OCL POWER AMPLIFIER circuit diagram?coz it so blurred...thanks more power