The following diagram is the FM tracking transmitter based on 4 transistors. No additional notes for this tracking transmitter diagram, try to discover this circuit by yourself.. 🙂
Components list:
R1 = 100K Ohms
R2 = 10 Ohms
R3 = 47K Ohms
R4 = 220 Ohms
C1 = 4.7uF/16V
C2, C5 = 1nF
C3 = 10 – 40 pF trimmer capacitor
C4 = 4.7pF
Q1 = 2N3906 PNP transistor
Q2, Q3, Q4 = 2N3904 NPN transistor
L1 = 4-5 turns of 22 ga. magnet wire close wound around 1/8″ non-conductive core
Antenna = 10 to 12″ hookup wire
With wide voltage supply (3-9v), this FM tracking transmitter can used 3V or 9V battery to operate.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…