This is the schematic diagram of 400W RMS stereo power amplifier which use power transistor to work. This amplifier in addition to providing good sound power, also with excellent quality and a high fidelity with low noise, to obtain the 400 watts we can put 2 speakers of 4 Ohms or 4 of 8 Ohms. The circuit require symmetrical power supply.
Transistors:
D1047 – 4 pieces
B817E – 4 pieces
A1015 – 6 pieces
TIP41C – 4 pieces
TIP42C – 4 pieces
Resistors:
6.8 ohms – 1W (blue, gray, gold) – 4 pieces
100 ohms – 1W (brown, black, brown) – 4 pieces
18K – 1 / 2W (brown, gray, orange) – 4 pieces
1K – 1 / 2W (black brown, red) – 2 pieces
10 ohms – 1W (brown, black, black) – 4 pieces
270 ohms – 1 / 2W (red, violet, brown) – 2 pieces
10K – 1 / 2W (brown, black, orange) – 2 pieces
330 ohms – 1 / 2W (orange, orange, brown) – 2 pieces
56 ohms – 1 / 2W (green, black) – 2 pieces
27 ohms – 1W (red, violet, black) – 2 pieces
820 ohms – 1 / 2W (gray, red, brown) – 2 pieces
0.47 ohms – 5W – 8 pieces
Capacitors:
0.1uF/100v – 4 pieces
47uF/63v – 2 pieces
2.2uF/100v – 2 pieces
330pF (ceramic) – 2 pieces
4700uF/63v – 2 pieces
Miscellaneous:
Diode 1N4004 – 10 pieces
Diode P600J – 4 pieces
2 coils of 10 turns with 1/4 copper core 18.
7 amp 33x33v transformer – 2 pieces
The power supply circuit is simple, you may use 10A transformer and 6800uf of capacitor. The diode value refer to the current value from transformer and it should be have higher value. For example if you use 7A transformer, then use 10A diodes.
This is the input connection for 400W RMS stereo power amplifier with volume control using a stereo potensiometer.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
where is the bottom pcb design
Please I want amplifier circuit to run horn 16 ohm 35 watt and 12-volt source is a car battery and will enclose some pictures of machine I know well I hope it's a very bad attention please.