This is the diagram of 4W stereo power amplifier built based stereo power IC LM2877 with a few of external components. The circuit required single power supply with voltage range of 6VDC – 24VDC. Heatsink is a must to prevent over heating on the IC.
About LM2877:
The LM2877 is known as a monolithic dual/stereo power audio amplifier produced to deliver 4W/channel continuous into 8X loads. The LM2877 is designed to work along with a few external components, and still give flexibility for use in stereo phonographs, tape recorders and AM-FM stereo receivers, and so on. Each individual power amplifier is biased from a general internal regulator to present high power supply rejection and output Q point centering. The LM2877 is internally compensated for all gains higher than 10, and comes in an 11-lead single-in-line package.
Download LM2877 datasheet for this amplifier project reference:
» Download Link
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…