This is the circuit diagram of 70W OCL power amplifier with output power of 70 watts single channel. It uses power transistor TIP2955 and TIP3055 as main component. The power supply used for this amplifier is a symmetrical / dual polarity power supply with output voltage 25V – 32V. This amplifier dan be used to drive the 4-16 Ohms loudspeaker. For stereo sound system application, you need to make two similar circuit and use 5A transformer for power supply.
What is OCL Amplifier?
An OCL amplifier (output capacitor-less amplifier) is any audio amplifier with direct-coupled capacitorless output. Typically, OCL amplifiers can be any of several amplifier classes, and typically have a push-pull output stage (wikipedia).
Advantages of OCL amplifiers over capacitor-coupled amplifiers include:
I wish you luck with this 70W OCL power amplifier project. 🙂
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…