Categories: AudioLinear Amplifier

80W Audio Amplifier Using TDA7295

Below is a 80W audio amplifier circuit is constructed by using a power IC TDA7295. With a very simple design, makes this circuit very easy to build. TDA7295 has many features to support your audio system, the most important is that the IC has very low distortion and very low noise feature.

Schematic diagram:

PCB Layout:

Circuit Notes:

  • Power supply voltage should not exceed 40V.
  • Use stable and regulated power supply. The power supply should be hasĀ  minimum current outputĀ  2A.
  • Use heatsink to prevent overheating on the power IC.

About TDA7295:

The TDA7295 is a monolithic integrated circuit in Multiwatt15 package, intended for use as audio class AB amplifier in Hi-Fi field applications such as home theatre and topclass TV. The wide voltage range and to the high out current capability make the TDA7295 able to supply the highest power into both 4W and 8W loads even in presence of poor supply regulation, with high Supply Voltage Rejection.

The built in muting function with turn on delay simplifies the remote operation avoiding switching on-off noises.

Dual Polarity Power Supply Scheme Diagram:

Use Minimum 2A center tap transformer for maximum result for mono/single channel application. Change the capacitor with higher value (about 6800 uF). Recommended supply voltage is 40V.

Download the datasheet document for your reference to optimize this circuit diagram.
Download TDA7295 datasheet PDF from the following link:
[wpdm_file id=66]

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago