This is the circuit diagram of ATmega8535 Line Follower / Line Tracker robot. The circuit taken from the tutorial documentation. You may download the full tutorial at the end of this article.
The ATmega8535 line follower robot uses 8 pieces of proximity sensor module. The sensor module use photodioda for detecting the reflection of light from the line/floor.
Proximity / Line Detector circuit:
ATmega8535 is a low cost and great microcontroller for your robot. This microcontroller is very easy to use, very easy to find, very easy to program. In this tutorial, we used C programming language.
Microcontroller ATmega8535 circuit:
The motor driver L298 able to control the motor with current output up to 2A for single DC motor. For double DC motors, there should be up to 1A for each output channel. This motor driver is very good for small and medium DC motor. L298 is great motor driver for small and medium size or robot such as line follower robot and fire fighter robot.
Motor Driver circuit with L298:
Download the complete ATmega8535 line follower robot tutorial which contains schematic diagram, robot design and source code in PDF version (Indonesian language):
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Nice project
DC Motor Controller using Transistor TIP31