Categories: Misc

Audio/Video to UHF TV Signal Converter (Modulator)

This is the circuit diagram of audio/video modulator. The circuit will convert an audio and video signal into a UHF TV signal. It’s desired to connect a video signal originating from a camera or other video source to a normal TV set. The audio and video signal is converted into a UHF TV signal so that the signal can be received through the TV antenna input.

Audio/Video to UHF TV Signal – Parts List

R1 : 47
R2 : 100
R3 : 560
R4 : 1K
R5 : 1K
R6 : 1K
R7 : 10K
R8 : 1K5
R9 : 1K5
R10 : 1K5
R11 : 2K7
R12 : 2K7
R13 : 2K7
R14 : 5K6
R15 : 270K
RV1 : 50K (47K)
RV2 : 1K
ZD1 : 11V
ZD2 : 6V2
C1 : 3pF
C2 : 3pF
C3 : 3pF
C4 : 1pF
C5 : 3pF
C6 : 10pF
C7 : 15pF
C8 : 22pF
C9 : 33pF
C10 : 56pF
C11 : 100pF
C12 : 100pF
C13 : 180pF
C14 : 470pF
C15 : 1nF
C16 : 1nF
C17 : 1nF
C18 : 1nF
C19 : 1nF
C20 : 4?7
C21 : 4?7
C22 : 10?F
C23 : 10?F
C24 : 220?F
CV1 : 5pF
T1 : BC547B
T2 : MPSH10
T3 : MPSH10
T4 : BFR90
L4 : 10,7MHz
L5 : 10?H
LD1 : Red

High Frequency Inductor Windings
This is how to make high frequency inductors for L1, L2 and L3:

  • Cut 3 lengths of the 0.6mm wire supplied to the exact length.
  • Scrape the enamel off the ends of each length of wire with a sharp knife for about 5 mm and tin the ends.
  • Make up the windings on a gimlet of 3.5mm diameter.


Download the application note of Audio/Video to UHF TV signal converter:

circuit diagram

View Comments

  • Hi,
    I have two questions
    1- what about the voltage?
    2- there is "L5 : 10μH" in the parts list but i can't find it in the schematic!
    Thank you

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago