This is a very basic circuit diagram of 3 band tone control. This basic tone control circuit was originally intended for home audio use, but should be able to be hacked into an effect circuit with very minor modification.
Resistance value of resistor R1 is left up to the user depending on gain needs, R2 is unknown – for experiment purpose. The op-amps are not critical, any standard ones could be used (eq: 741, LM324, etc).
Power supply used for this circuit depends the op-amp IC used. Use the IC datasheet to know the recommended voltage. Some op-amp IC needs symmetrical power supply to work, just find the op-amp which require general power supply (asymmetrical). A regulated power supply will be better for this circuit.
For better sound performance, use high quality component such MKM capacitor (non polar), tantalum capacitor (bipolar), metalfilm resistor, etc.
Download basic tone control circuit in PDF document:
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
2000watt ka pura pdf chhahiye
what is the value of the gain resistor r1