Here is the circuit diagram and PCB design for relatively low cost DIY bass guitar preamp pedal uses FET K117 or equivalent. There is a bit difficult to build this kind circuit project, it’s require a good knowledge in electronics. This preamp has several features for the bass guitar instrument such as attenuator, low cut, mid control and Hi boost. The circuit has some control: volume level, high frequency, high-mid frequency, low-mid frequency, bass frequency. Boost level and master level control also included in this circuit design.
Power supply circuit for bass guitar preamp also included in the PCB design. Simply connect the power supply section to the output of transformer with the secondary 15 + 15 V / 500 mA.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
gostaria de saber os valores dos potenciômetros pois no esquema não são especificados e no lay-out de montagem não está legivel!