Categories: Audio

Dynamic Mic Compressor

The circuit below is a Dynamic Mic Compressor circuit which is simple, easy to built, inexpensive but the results are quite satisfactory. Audio output sounded outstanding.

The principle of this circuit is very simple, the first transistor is used as microphone pre-amplifier. Then a second transistor used as a buffer. And the third transistor is a feedback circuit. A very sensitive electret microphone used in this circuit.

Supply voltage of this Dynamic Mic Compressor circuit must be 12 Volt. Highly recommended to use its own power supply, do not use a shared power supply from another electronic circuit module. Regulated circuit with fine/good cable and good grounding is recommended to minimize hum.

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago